Conditions of Use and Storage

The Device should not be stored in areas that are too hot (in excess of 113 degrees F) or too cold (below 32 degrees F):
a. The Device could explode if left inside a vehicle or other closed environment where the temperature exceeds 140 degrees F.
b. The Device should not be exposed to direct sunlight for long periods (such as on the dashboard or the seat of a car).
c. It is suggested that the Device’s operating temperature be maintained between 32 degrees F and 113 degrees F.

Do not store the Device near magnetic fields or heat sources such as on top of or inside radiators, microwave ovens, hot stoves nor in high pressure containers, otherwise the battery or the Device may be damaged, overheat or possibly cause a fire.

To maintain battery life, the Customer should:
a. An adapter with a maximum power output of less than 15W shall be used to charge the device.
b. Avoid keeping the Device under charge once the battery charge is completed signal lamp comes on. Overcharging may impair battery performance.
c. After a prolonged period of non-use, recharge the batteries before using. The batteries tend to self-discharge, which means that they will slowly discharge even if the Device is not switched on.
d. Disconnect the charger from the wall power when not in use.
e. Because the use of generic chargers may cause deterioration of performance or damage to the Device, use only chargers and accessories that comply with standards or that are supplied in the package.

Customer should never:
a. Use damaged power cords or plugs and never pull on the cord to remove the plug from the socket.
b. Disconnect the charger by pulling on the power cord.
c. Touch the power cord with wet hands.
d. Bend or damage the power cord.
e. Charge the device while it is still attached to your pet.
f. Touch the Device with wet hands while charging the battery.
g. Short-circuit the charger or the battery.
h. Subject the charger or the Device to impacts.
i. Charge the battery with a transformer rated less than 0.5A or over 15W.
j. Use damaged battery chargers.
k. Use during a thunderstorm.
l. Dispose of the battery in a fire or hot oven and never cut the battery, which may explode.
m. Leave a battery in an extremely hot environment, which may cause an explosion or the release of flammable liquids or gases.
n. Leave a battery in a place where the pressure is extremely low, which could cause an explosion or the escape of flammable liquids or gases.

The Device is equipped with a lithium-ion (“Li-ion”) battery. Therefore, the Customer should never open, puncture or subject the Device or the battery to falls or impacts:
a. Altered or damaged Li-Ion batteries may spontaneously catch fire.
b. During charging do not expose the Device to temperatures below 32 degrees F or above 113 degrees F.
c. During normal operation do not expose the Device to temperatures below 32 degrees F or above 113 degrees F.

d. Exposure of the Device to excessively cold or hot temperatures may impair the battery’s performance or cause deformation of the components.

COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference; and

2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

This device complies with Industry Canada’s license-exempt RSS standards. Operation is subject to the following two conditions:

1. This device may not cause interference; and

2. This device must accept any interference, including interference that may cause undesired operation of the device.